COM port settings for Magellan MobileMapper 6

All about DigiTerra Explorer 5 mobile GIS software: questions and answers, tips and tricks. You can share information and knowledge about DigiTerra Explorer 5 with other users, by using this forum.
User avatar
Balazs Hober
Site Admin
Posts: 260
Joined: Fri Aug 08, 2008 12:53 am
Location: Hungary, Budapest
Contact:

COM port settings for Magellan MobileMapper 6

Postby Balazs Hober » Tue Nov 18, 2008 2:42 pm

1.) First, read the MM6 FAQs v2.1 page 5/9, question Nr. 23:
Link: ftp://ftp.magellangps.com/Mobile%20Mapp ... 20v2.1.pdf
23. How should I configure a COM port for NMEA output (to a GIS software
running on the device)?
The MobileMapper 6’s GPS engine will output the NMEA 0183 V2.2 data (to a GIS SW
installed on the device, not to an external device). The configuration of the GPS port is: 9600
baud rate, 8 bit, no parity. It appears in the operating system as COM1 (physical port). COM1
is a two way port, that allows one to manage SiRF GPS engine by means of SiRF control
commands.
It is also possible to configure a GPS program virtual port e.g. COM2 port (tap Start > Settings
> System > External GPS). The virtual port is one-way only, thus the GIS application will be
able to read NMEA data, but will not be able to send SiRF control commands.
Note: If the virtual port COM is used by any application, the physical port COM1 is no longer
available until the virtual port COM is free.

2.) Next, open the Settings panel > GPS tab and use: COM2, 9600
or find the GPS port automatically with the Search button on the same panel.
The automatic port searching function for MobileMapper 6 works correctly in DigiTerra Explorer 5.8.11.14 or above.

Download link to the latest version:
http://digiterra.hu/en/support/downloa ... de_package

Return to “DigiTerra Explorer 5”

Who is online

Users browsing this forum: No registered users and 1 guest